Stacked patch in feko

Status
Not open for further replies.
J

JincyRachel

Newbie level 4
Joined
Feb 19, 2014
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
33
I made a stacked patch structure in FEKO, but I'm not able to run it, because of an error in the feed. I found in some papers that only a line feed can be given, but its not working... Plz help me...
 

JincyRachel said:
I made a stacked patch structure in FEKO, but I'm not able to run it, because of an error in the feed. I found in some papers that only a line feed can be given, but its not working... Plz help me...
Click to expand...

What paper is that? Apart from the line feed you can also use the following feeds:
1. an edge port placed on an edge that separates two surfaces (when i.e. placing a feed on a metallic surface)
2. a waveguide port if the feed is modelled with a coaxial cable connection
3. a FEM current source if the patch is modelled with the FEM/MOM or FEM/MLFMM
4. a microstrip port (that is referenced to an infinite ground) placed on the edge of a microstrip line where the dielectric is modelled as infinite in the XY plane

What error are you getting?
 

The error I got is that after I unioned all my antenna parts (line feed, ground and substrate), the port appears to have been split into 3 parts on its own, and i cannot proceed to the meshing part. I made Port1. But this gets divided as : Port1_1, Port1_2 and Port1_3.....
 

i'm using CADFEKO Suite 5.5.... The port is shown as a suspect element.. (a yellow triangle with a question mark inside)
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…