msp430f1611 spi
Hi everyone,
I'm trying to interface an external ADC with the MSP430F1611's SPI.
I've written the code to initialize the SPI (seen below), but I now want to test my Init_SPI by writing some data to it and probing it using the scope to see that I've written data to it.
Eventually, I want to get data from an external ADC using SPI and store it in memory.
Can anyone point me in the right direction?
Thank you so much! Much appreciated.
- Amy
====================INIT_SPI=========================
void Init_SPI(void)
{
P3SEL |= 0x3F; // Select P3.0,1,2,3,4,5
P3DIR |= 0x0B; // Select P3.1,3 as output directions
P3OUT &= ~0x01;
ME1 |= USPIE0; // ENABLE USART0 SPI
UCTL0 |= CHAR + SYNC + MM; // 8-bit data, SPI mode
UTCTL0 |= CKPH + CKPL + SSEL1; // Inv.delay, ACLK
UBR00 = 0x2A; // Baud Rate = 115200
UBR10 = 0x0;
UMCTL0 = 0x0; // Clear Modulation
UCTL0 &= ~SWRST; // Initialize USART state machine
//_BIS_SR(LPM3_bits + GIE); // Enter LPM0 w/interrupt
} //end Init_SPI
===============================================