Fom
Advanced Member level 2
I have a problem I can't solve.
Sometimes when I run long-time simulation by Spectre I need to restat the simulation from checkpoint. I did it before with SpectreS without any problem. But after I'm switched to Spectre I can't restart simulation from checkpoint. Spectre always give an error message about convergence. I don't change anything in schematic or simulation setup. I only try to restart from checkpoint.
Anybody have a solution?
Thanks.
Sometimes when I run long-time simulation by Spectre I need to restat the simulation from checkpoint. I did it before with SpectreS without any problem. But after I'm switched to Spectre I can't restart simulation from checkpoint. Spectre always give an error message about convergence. I don't change anything in schematic or simulation setup. I only try to restart from checkpoint.
Anybody have a solution?
Thanks.