fanios
Newbie level 6
- Joined
- Dec 8, 2010
- Messages
- 12
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,366
Hi , could anyone tell me which configuration mode should i use to program amp and adc. Also,Spartan 3an's user guide (ug334) i can't understand somethig ...page 76 , figure 9-6. At sample point i turn off spi_sck and for many cycles?
Manual says that the maximum sample rate is approximately 1,5Mhz. I suppose that is logical because the minimum number of cycles for each sample is 34.50Mhz/34=1,5Mhz . But from the figure 9-6 i can't understand what about the cycles required for sample point (when ad_conv goes high). If someone knows please help.
Manual says that the maximum sample rate is approximately 1,5Mhz. I suppose that is logical because the minimum number of cycles for each sample is 34.50Mhz/34=1,5Mhz . But from the figure 9-6 i can't understand what about the cycles required for sample point (when ad_conv goes high). If someone knows please help.