Soft Uart transmission in pic18f452

char i, error, byte_read;                 // Auxiliary variables

void main(){

  ANSEL  = 0;                             // Configure AN pins as digital I/O
  ANSELH = 0;
  
  TRISB = 0x00;                           // Set PORTB as output (error signalization)
  PORTB = 0;                              // No error

  error = Soft_UART_Init(&PORTC, 7, 6, 14400, 0); // Initialize Soft UART at 14400 bps
  if (error > 0) {
    PORTB = error;                        // Signalize Init error
    while(1) ;                            // Stop program
  }
  Delay_ms(100);

  for (i = 'z'; i >= 'A'; i--) {          // Send bytes from 'z' downto 'A'
    Soft_UART_Write(i);
    Delay_ms(100);
  }
   
  while(1) {                              // Endless loop
    byte_read = Soft_UART_Read(&error);   // Read byte, then test error flag
    if (error)                            // If error was detected
      PORTB = error;                      //   signal it on PORTB
    else
      Soft_UART_Write(byte_read);         // If error was not detected, return byte read
    }      
}

char error, byte_read;
int i;
char text[15]="vote casted";  
void Soft_UART_Write_Text(char *text) {
     unsigned int x = 0;
     for(x = 0; x <= strlen(text); x++) {
         Soft_UART_Write(text[x]);
     }
 }               // Auxiliary variables
void main(){

  //ANSEL  = 0;                             // Configure AN pins as digital I/O
  //ANSELH = 0;

  TRISB = 0x00;                           // Set PORTB as output (error signalization)
  PORTB = 0;                              // No error

  error = Soft_UART_Init(&PORTC, 17, 16, 9600, 0); // Initialize Soft UART at 14400 bps
  if (error > 0) {
    PORTB = error;                        // Signalize Init error
    while(1) ;                            // Stop program
  }
  Delay_ms(100);

    Soft_UART_Write_Text(text);
}