Soft Uart In 8051controller

[SurekhaIris]

How many soft uart can we have in 8051 controller,i require 4 softuart

whether is it possible

 

[Jigar 4 Electronics]

Well actually you've so many methods to do that.
and you can have as many UARTs as you want (depends on available GPIOs)

the very simple and basic which I like is :

suppose you've 2 device to get connect with master. (I am assuming both are programmable)

connect the Master's Tx to Slave1 and Slave2 's Rx directly, choose same Baud rate for all the three devices.
assign unique code/character to each of the slaves, so that when the Master puts out the Unique Code on the Bus, only the called-upon slave returns acknowledge/required data.
this concept is similar to I2C protocol and would be interesting to work with, also with this approach you can have several slave devices and you are not limited only to 2 slaves

I've got this from here :https://www.8051projects.net/t11828...tiple-serial-port-8051-at89c51.htm#post_11836

you can have other methods also to do this.
Please read the above linked blog THOROUGHLY.

 

[madhusuthanan]

hi

its i2c or uart?

 

[SurekhaIris]

it is UART(Softuart )

 

[madhusuthanan]

if it is i2c means we can use it.

 

[SurekhaIris]

No,it is not i2c.is it not possible for simple UART
Thanks.

 

[IanP]

it is UART(Softuart )

If you don't want to lose data then you can have only one extra software UART that will be using one of EXTINT (0 or 1) as the Rx input and one of timers to clock it ..
That makes the total of UARTS 2: one already existing (hardware) and one in software ..

:wink:
IanP

 

[SurekhaIris]

Thanks for the reply,i already implement one softuart but i require two more is it possible to implement.

Thanks for the reply

 

[madhusuthanan]

no you can go for i2c/i2s communication for more devices connected to in single communication

 

[IanP]

... i already implement one softuart but i require two more is it possible to implement ...

Not for simultaneous use ..
:wink:
IanP