Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SMD parallel programmer - Atmega8

Status
Not open for further replies.
V

Vermes

Advanced Member level 4
Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


It is a parallel programmer with some modifications, mainly the change of several hole elements on SMD and shorten the jumpers. The programmer works very well so far. It was tested on Atmega8, 16, 162, 168, 32 and Attiny2313.
Pictures:


35_1288446928.jpg


Link to original thread (useful attachment) – Programator równoległy + PORADNIK
 

Nice, but this is smaller :

Bottom.jpgCircuit.gifPodrzani Flash.jpegPodrzani uC.jpegTop.jpgSTK200 ISP.png

All goes into small PCB can be placed into 25pin conector plastic case.

Software is ispprog 1.2.0.56 or newer.

Replacement for 74LVC244 can be 74HC244, but 74HCT244 cant!!!

Must be low voltage HCT need 4,5V, and HC need only 2V.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top