VINAY_RAO
Junior Member level 2
hi,,
I am using ic5141 and wrote a simple verilog-ams code for 1-bit DAC where input is digital signal and output is analog.After that i instantiated in schematic window for simulating it.
I reffered manuels to simulate this but i am not getting any proper idea for simulating mixed design.
For simulating any design, is it compulsory to go for "config"
views rather than simple schematic view??
Whats the need of config view if we dnt have any hierarchial design??
I am using ic5141 and wrote a simple verilog-ams code for 1-bit DAC where input is digital signal and output is analog.After that i instantiated in schematic window for simulating it.
I reffered manuels to simulate this but i am not getting any proper idea for simulating mixed design.
For simulating any design, is it compulsory to go for "config"
views rather than simple schematic view??
Whats the need of config view if we dnt have any hierarchial design??