Simulate Flex-Rigid board in Hyperlynx

Status
Not open for further replies.
P

pavel47

Member level 4
Joined
Nov 8, 2005
Messages
68
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Switzerland
Visit site
Activity points
1,790
Hello,

Is there some technique, allowing to simulate Flex-Rigid PCB in HyperLynx.
The consists in the following Flex-Rigid feature: it contains more than 1 stackup.

Any ideas ?

Thanks in advavce.

Pavel
 

One of the possible methods is to make two copies of your Flex-rigid PCB. The rigid part of the PCB is, say RIGID.pcb and the flex part is say FLEX.pcb. Generate two separate .hyp files from these two files and later combine them in HyperLynx using the Multi board feature of the tool. But make sure to properly assign a mating connector having proper pin assignment in these connectors.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…