Signal I/O standard for GTH and GTR

Status
Not open for further replies.
E

engr_joni_ee

Advanced Member level 3
Joined
Nov 3, 2018
Messages
822
Helped
2
Reputation
4
Reaction score
7
Trophy points
18
Activity points
6,875
In Xilinx UltraScale+ MPSoC ZCU102, there are two peripherals which are connected to GTH transceiver on PL side. These are SFP+ and HDMI In/Out. What is the signaling standard used in both, CML signaling standard or any other ?

In addition, I also see that there are GTR (6 Gbps) on which PCIe, USB3.0, SATA, and DisplayPort are connected in ZCU 102. Which signaling standard is used for these ? CML or any other ?

I appreciate your time and consideration to answer these questions about signaling standard for high speed GTH/GTR transceivers.
 

Sort by date Sort by votes
Presumed all these interface are working correctly in ZCU 102 dev board, what's the objective of your question? Did you already review UltraScale+ datasheet, ZCU 102 schematic, specification of the respective interfaces?
 

Upvote 0 Downvote
Yes, I found answer.

"The GTH transceiver TX driver is a high-speed current-mode differential output buffer." UG576 states at page 167
"The PS-GTR transceiver TX driver is a high-speed voltage-mode differential output buffer." UG1085 states at page 813
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…