Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sigma delta ADC - simulink model

Status
Not open for further replies.
E

ElEngineer

Newbie level 3
Newbie level 3
Joined
Apr 16, 2010
Messages
4
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,299
I have tried to estimate the SNR of the sigma delta conversion after the sinc^3 filter and got lots of noise at the low frequency end. It looks like the opposite of noise shaping, see attached. When fft of the bitstream is plot the SNR is almost twice as high for the same frequency. Am I using the sampling rate a lot higher than the signal I am looking at?
Thanks!
 

Never mind, I have found the error in my code - needed to account for the transition delay of the decimation filter. After I discarded those initial bits from the bitstram (the higher the decimation rate - the more bits need to be discarded) the SNR is correct.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top