[PIC] short or very heavy load on VPP was detected

Status
Not open for further replies.
In the second step of the PICkit troubleshooting you try to verify the VPP , however I get this error messages "short or very heavy load on VPP was detected"
 

Can you post a schematic of the circuit you are utilizing to program the PIC? Or is this a commercial development board?

Is this the first time programming the device? Or have you successfully programmed it in a different circuit?


BigDog
 

I can not post schematic of the circuit.. this is a commercial board. I have use the PIC to program several or quite a few boards with this Pic.. I believe that I have place the PIC on incorrectly... just was wondering if I would have to buy a new PIC... or figure out what device is damaged because of " incorrect polaity" placement.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…