[AVR] Serial port problem atmega 32

Status
Not open for further replies.
S

shoaib.123

Newbie level 1
Joined
May 28, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
8
hello everyone,
i am facing a major probelm when i want to send data via serial port from atmega32 to computer. i'm using atmel evaluation board by pollin version 2.0.1
there are jumpers for portD and then a max232 after those. i'm able to get pulses on oscilloscope on jumpers for rx,tx and pins for which i'm trying o get output but after max 232 no output.
what can be the issue?
need serious help
 

Have you put in jumper 1 and 2?
Where do you get the pulses on the rx from?
Have you enabled the UART, and the pins correctly?

Is your software valid?
On the RS232 connector J6, pin 2 is the output, and 3 is the input from the (PC). You should start with nothing connected to J6, and use the oscilloscope to see if there are any life.
If you connect J6.2 and .3 together, you will see what you transmit(tx) on the input (rx).

To get more from us, you need to post the code and maybe a picture of the board setup. We are not psychic you know.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…