Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Sensing RSSI port of Xbee pro S2C using Arduino Nano

Status
Not open for further replies.
D

darkmatter_1729

Newbie level 4
Newbie level 4
Joined
Sep 13, 2023
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
50
Hello people,

I wanted to sense the RSSI port when it is high using Arduino Nano. I'm reading 1.7V at the RSSI port. From the forum I got to know that it is not possible to sense any voltage below 3V from a digital I/O pin. So I used a level shifter using this page to get an output of 5V. Circuit worked fine when I gave 1.7Vdc. But i'm unable to get signal using Xbee pro S2C.

Any help will be appreciated
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top