schmitt trigger using just diodes?

Status
Not open for further replies.

neazoi

Advanced Member level 6
Joined
Jan 5, 2008
Messages
4,157
Helped
13
Reputation
26
Reaction score
15
Trophy points
1,318
Location
Greece
www.microwave.gr
Activity points
37,198
Is it possible to make a schmitt trigger using just diodes (zeners etc)?
I need a voltage of about less than 1v to be read as 0v and voltage of about more than 1v to be read as logic 1
 

Schmitt trigger - no way, it would be impossible to make a circuit with different high and low thresholds.

As a simple high voltage detector - maybe but it depends on the logic level you want out of it. Basically, you can use the diodes as fixed voltage droppers, as long as the high input voltage makes them conduct you could measure something at the output but if the input fell below the Vf threshold, the output would disappear (barring leakage currents). It wouldn't be very good or fast acting and the threshold voltage would be poorly defined and gradual rather than rapidly switching state.

Brian.
 

You need some sort of active circuit. A comparator such as an LM339 with a small amount of positive feedback for the Schmitt trigger action would work well.
 

Actually, I lied. I think it is possible to make one using a tunnel diode but the threshold voltage would be fixed and the output would be a very fast pulse (a few nS at best). It wouldn't be practical to make and would be expensive to buy. Tunnel diodes are hard to find!

Brian.
 

A Diac would sort of a schmitt trigger function, as it switches from withstanding to conduction.
To release it from the conduction state it will be a function of current, not voltage.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…