Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Scanalogic 1 - Signal Analyzer

Status
Not open for further replies.
tpetar

tpetar

Advanced Member level 7
Joined
Sep 27, 2010
Messages
6,417
Helped
1,713
Reputation
3,456
Reaction score
1,673
Trophy points
1,393
Location
Pancevo-Belgrade, Serbia
Activity points
37,363
Web address : **broken link removed**
RS232 version. Firmware files for ATMega16 is on that page (for 8,12, and 16MHz speeds). Also link for PC software is here.


**broken link removed**

**broken link removed**

**broken link removed**

**broken link removed**

**broken link removed**
 

it is a very useful device... I think Programing too needed, in a bit advanced level.. isn't it?
 

uC must be programmed with hex file (firmware). Programming can be done over any AVR programmer, such USBasp.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top