Hi,
some SAR ADCs have interal amplifier. They are much easier to drive. ..
But we talk about ADCs without amplifier.
They usually have a "hold" capacitor. The built in "sample and hold" circuit connects the hold capacitor to the output only during "sample" phase.
Within the time of the sample pahse the capacitor needs to be charged - best to an error of less than 1 LSB.
If you have an input resistor then it builds an RC circuit with the internal hold capacitor.
For a 200kSmpl/s ADC maybe the sample time is 1us. With a 16 bit ADC one LSB = 0.00001526 of fullscale.
Within one RC constant the capacitor is charged with 37% error = 0.37.
for two RC the error is 0.37 x 0.37 = 0.137;
for 3 RC--> 0.051
and so on..
you need more than 11 RC (fixed value for 16 bit ADCs) to charge to an error of less than 0.00001526
the mathematical calcualtion is: log(0.000015)/log(0.37) = 11.2
now you know 11 RC are 1us. then you can calculate that one RC = 91ns.
Maybe the charge capacitor C = 6pF. then you can calculate "R". R = 91ns / 6pF = 15kOhms.
This means you should not use source resistor of more than 15kOhms. With no additional C.
****
An external RC can be used as antialiasing filter, and/or to improve OPAMP driver stability.
For an antialiasing: then usually the external capacitor is much larger than the internal, so the internal capacitor gives no relevant error.
For stability reasons: You need an OPAMP that can drive low ohmic loads and should stabilize much faster than the "sample" time of the ADC. Often you find a value of xx nanoseconds to 99% of target value.
This is 1% error or 0.01. But you want 0.000015 within 1us. log(0.000015)/log(0.01) = 2.4 ; 2.4 times xx ns = 1us --> xx = 414ns,
You need to find an OPAMP that is able to react on a step input with less than 414ns to 99% of the end value.
(But this is for worst case... the error step won´t be 100% full scale for example...)
You will soon find out that a 741 won´t do this. Then better first try without an OPAMP, if you are not satisfied with the result you may add an OPAMP - check if it improves accuracy.
A lot of good OPAMP can drive 600 Ohms loads without instability. If you now take the 91ns RC of the calcualtions above you get a max. C of 151pF (worst case)
In reality a 1nF capacitor may be a good choice.
****
Much calcualtions....
But as said before it is "worst case" when you want to go to the limit.
Relax! With your application you are far away...
Klaus