d_a_l_3
Junior Member level 1
- Joined
- Jun 8, 2007
- Messages
- 16
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Croatia
- Activity points
- 1,387
Hi all
I got one spare digitizer and wanted to corvert to usable touch board but don't have pinouts, this is scanned picture
picture is small but this is all I can zoom
I know that this 2 connected from left can be GND but rest is problem, it is capacitive so it have to be i2C or SPI
Also on board there is 3 serial MXT154 (small one) and one big (controller) MXT1386-u
if someone know how to identify pins I would be very thankful
P.S.
If is wrong forume remove to right one, didn't know were to post
Thx
I got one spare digitizer and wanted to corvert to usable touch board but don't have pinouts, this is scanned picture
picture is small but this is all I can zoom
I know that this 2 connected from left can be GND but rest is problem, it is capacitive so it have to be i2C or SPI
Also on board there is 3 serial MXT154 (small one) and one big (controller) MXT1386-u
if someone know how to identify pins I would be very thankful
P.S.
If is wrong forume remove to right one, didn't know were to post
Thx