Saber/Modelsim licensing problem

Status
Not open for further replies.
B

boondoggle

Newbie level 2
Joined
Sep 5, 2003
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Somewhere in Minnesota
Activity points
21
co-simulation saber/modelsim

Hello,

I've been trying to test out Saber's co-sim capabilities, but each time
I try to run a mixed-signal (spice + vhdl) example, Saber quits
with the following error message:

*** ERROR "SEC_NOT_AUTHORIZED" *** You need the "ModelSim"
package license to use Saber/ModelSim.

I'm running 2002.2 and the license file has a valid SABER_MODELSIM
feature. The Saber/Modelsim interface was installed (as far as
I can tell). I believe I've followed all the environment setup
instructions to the letter.

Any ideas on what's wrong/missing???

Thanks.
 

Dear all,
I encounter the same problem. I run Saber Designer and Modelsim, but I could not perform any co-simulation, even if the license feature Saber_modelsim is enabled. I assume it has to do with setting some general environment variables. The error message I get is:

*** ERROR "SEC_NOT_AUTHORIZED" *** You need the "ModelSim" package license to
use Saber/ModelSim.

As I have said, the license has this feature though....
Did anyone manage to to a Saber-Modelsim co-simulation out there?
 

may be changle the flexm server
 

Where do you get the license file?


Illegal request. You have been warned.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…