Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Running code warrior through command line

Status
Not open for further replies.
C

cheenu02

Junior Member level 3
Junior Member level 3
Joined
Jun 16, 2011
Messages
31
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,500
hi,
I am trying to run the code warrior through command prompt.
My TCL commands are in following order

debug
go
wait 5000
stop
kill
quitIDE

No command is executing after go command.
I need to close the debugger and IDE after run.

Please help me..
Thank you.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top