Running a specific limited DRC in eagle pro?

Status
Not open for further replies.
T

treez

Guest
Hello,

I wish to run a DRC on the PCB but just only to check for distance from copper to edge of board.

How do i do this alone?
 

Other than creating a DRC file with really small (or large) limits for everything else, I think you could possibly do it by writing a ULP. I would simply run the DRC and scroll down to look for the "DIMENSION" errors.

Keith.
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…