run servo motor using USB cable

Status
Not open for further replies.
R

Rajashri.Shevale

Junior Member level 2
Joined
Dec 31, 2014
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Location
India
Visit site
Activity points
164
can i replace given three pin servo motor cable by USB cable? If yes, then how?
my motor requires minimum 900mA current. is USB cable capable to provide that much of current?
 

Nope,
USB 2 is specified to 500mA @ 5V, additionally if you were looking to control the motor over USB you would need a modest micro controller to talk USB and interface it to whatever the motor needs as a control signal.

Regards, Dan.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…