Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Routing Problem in eagle

Status
Not open for further replies.
W

WhyWhy

Member level 4
Member level 4
Joined
Mar 18, 2013
Messages
68
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,779
Hi guys,

Normally my friend will use ripup and route to connect those error line after the autorouting for reducing the error after DRC.

Is there any easier way than the manual routing? Thanks

PCB.png

Regards,
YY
 

make changes in edit>>design rules>>clearance tab and try to route whole board manually.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top