Routing error with ares

[didiersee]

Hello everyone, I realized a small printed circuit with the ARES software from PROTEUS. The worry is a mistake that persists despite that I routed via a wired bridging. On the attached image you can see the white link (error) and the wired bridge that is nevertheless well connected. Does anyone know how to solve this problem?
NB: I am on PROTEUS 8.1 (ENGLISH)
Thanks in advance

 

[praveen24]

Hi, Check the properties of red colored track connection between the vias. It may be in non-electrical one.

 

[gauravkothari23]

Hello everyone, I realized a small printed circuit with the ARES software from PROTEUS. The worry is a mistake that persists despite that I routed via a wired bridging. On the attached image you can see the white link (error) and the wired bridge that is nevertheless well connected. Does anyone know how to solve this problem?
NB: I am on PROTEUS 8.1 (ENGLISH)
Thanks in advanceView attachment 139490

post your schamatic.
and there is no need to create a vias.
the transistor pin 1 can be routed from below the resistor R1. and pin 3 of U1 can directly be connected to R1.