Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Rotating Components in Multisim

Status
Not open for further replies.
M

mick the mend

Junior Member level 3
Junior Member level 3
Joined
Dec 31, 1999
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
103
Is it possible to rotate a component through anything other than 90 deg ie 45 in multisim?
I seem to remember that it was possible in an earlier version
 

I don't think so, you have to remake the symbol for doing this. Suppose you want a resistor that is tilt at 45' from horizontal axis. Use just use the editor to make a new symbol for it.

Added after 1 minutes:

Read this!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top