Rodix Feeder Cube CFR-94 Plus PARTS SENSING

Status
Not open for further replies.

unsaint32

Newbie level 1
Joined
Jun 21, 2014
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
9
Hi, we have a small machine that sends parts from hopper to conveyor line. It uses Rodix Feeder Cubes as a controller for a DC agitator/vibrator for the hopper.

One input sensor that sends ON signal to the hopper controller is getting erratic power supply (24V).

Whoever installed this machine did not label wires or cap off wires that are routed but not terminated. So I have to figure out which wires were originally terminated and now came off of the terminals, and which ones were not meant to be terminated.

The Rodix Feeder cube manual is here.

https://www.rodix.com/pdf/app_note/121-100-8240.pdf

Can you tell me what the terminal #1 is for? I am attaching the diagram.

Thanks.
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…