rf mems shunt switch simulation; s-parameter by ansoft hfss

Status
Not open for further replies.
D

danial_1860

Newbie level 4
Joined
Sep 1, 2009
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,318
hi evereybody
im trying to simulate a shunt capacitive switch on a cpw by ansoft hfss, but i have problems to excite the structure to obtain s-parameters. i dont know how and with witch wave port i should do the excitation. has anybody any idea??
 

im working on a cpw transmission line, not microstrip transmission line, also i dont know how to excite, with witch port, wave port or lumped port or...
 

Sorry, I didnt realise that u were talking about CPW. I think you should use a lumped port. and take a look at this thread:
https://www.edaboard.com/threads/88098/

If you dont have a ground plane you can probably use two ports at either side. I am almost sure I have seen a official ansoft example with this kind of setup.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…