RF Amplifier Design Switch Mode

[Tanvir56]

How to place a switch that is dependent on Time in a pushpull circuit in Advanced Design Systems for maximizing output power?

 

[BradtheRad]

The 555 IC might be adapted for your purposes. Its output terminal can source or sink 150 mA.

 

[Tanvir56]

The 555 IC might be adapted for your purposes. Its output terminal can source or sink 150 mA.

Actually, I want to know which component I will use in my schematic in Advanced Design System Software.

 

[FvM]

It depends. If you want to add an ideal switch, use SPDT_DYNAMIC with respective control source. If you want to model a real transistor, use a respective component.

 

[Tanvir56]

It depends. If you want to add an ideal switch, use SPDT_DYNAMIC with respective control source. If you want to model a real transistor, use a respective component.

Actually, I don't need to do model a real transistor. I need to do switching my schematic, which is dependent on time intervals. And the Vload would be pulsing after using switch mode in the schematic. I have attached a picture here. Can you support me to do this? I am using ADS software.

 

[Tanvir56]

Actually, I don't need to do model a real transistor. I need to do switching my schematic, which is dependent on time intervals. And the Vload would be pulsing after using switch mode in the schematic. I have attached a picture here. Can you support me to do this? I am using ADS software.