Review - Hardware Design

Status
Not open for further replies.
D

davidlee11

Newbie level 2
Joined
Jun 24, 2015
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
14


As a newbie, Switch section is designed according to my knowledge. Please let me know the review for this section.

Switch is connected with the microcontroller. I have tried to protect microcontroller from positive & negative spike. The distance of switch from microcontroller is approx. 6 Inches. Here Vcc is 3.3V & microcontroller also works on 3.3V.
The schematic for the switch section is attached.
 

A similar R/CR diode structure is built into every input. See ESD protection current. Ensure switch is isolated from finger discharges to signals with 15 mm clearance for 15kV isolation. Do you want cap at 0V on power up then pulled up with switch to ground and power up closure? DOes it have software controlled pullup on input?

Choose RC >> debounce time for switch depending on size /quality 1~10ms typ.switches.
 

The microcontroller will measure 0V when switch is pressed. It has software controlled pull up resistor.
 

Hi,

the switch ON time constant is about 110us (falling)
the switch OFF time constant is about 22ms (rising)

These values are OK even for debouncing.

The protection seems to be OK as well.

if a high energy positive pulse comes in, then it may lift the VCC voltage. Use an adequate bulk capacitor at vcc.

Klaus
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…