Hi,
Whats the favoured way for rev pol protection on a 3 phase , 3 diode bridge? Ayk, if a phase goes into neutral connector by mistake, and the neutral to one of the phase connectors, the voltage goes high and the magic smoke comes.
LTspice and PNG attached
Hi,
The attached circuit is the "standard" and well known way to protect
against accidental misconnection of the 3 phase half wave diode bridge.
(ie a phase and neutral getting accidentally swapped)
But as can be seen, its a huge amount of componentry.
Any lower_component_count ways?
The attached just has an input relay...it doesnt turn on if any phase and neutral are misconnected.