relay driver using uln2803 to switch on the lamp

Status
Not open for further replies.

BISH

Junior Member level 2
Joined
Nov 3, 2012
Messages
23
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,418
hi all,

i want "a relay driver circuit using uln2803 to switch on the lamp" in proteus
 

Connect input drive signal to ULN2803 input pin. Connect lamp between the corresponding output pin and +V. Connect pin 10 (COM) to +V. In Proteus, the common emitter pin of ULN2803 is hidden and is connected to ground.

By the way, for driving a single lamp, you can just use a transistor. You don't need to use ULN2803.

Hope this helps.
Tahmid.
 
Reactions: BISH

    BISH

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…