Reg:Copper Area On The PCB

Status
Not open for further replies.
S

sakthivel.eee

Junior Member level 3
Joined
Jun 19, 2009
Messages
31
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Location
Pune
Activity points
1,518
Dear All,
For SMD packages, We used to give Copper area on the PCB for heat dissipation (regulators ,MOSFETs Etc,). How to decide the size of copper area? Is there any calculation?


Thanks in Advance,

Regards,
Sakthi
 

hi
For regulators and mosfets, the amount of heat sink to be provided is usually given in the datasheet.
the datasheet says how much copper area should be poured for that component.
it usually says what ounce of copper to be used. Besides the datasheet information,
the copper area info. will also depend on the component location on the board.
As we use this copper to take out the heat from the component, if we can take more heat by radiation method (which depends on our pcb location), then less copper is needed. because copper takes heat through conduction.

hope this info. helps u. if so, click on helped me.

Regards
 

THERE IS , BUT I FORGET..REMEMBER THAT AFTER A RADIUS OF ABOUT HALF INCH, ADDING FURTHER COPPER HAS LITTLE EXTRA COOLING EFFECT

(woooops!...sorry about the capitals)

there is an application note on this.

by either

onsemi
irf
or similar
 

If u know any application note regarding this, Plz post link

Sakthi
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…