Reflection's in PCB

nikhil_56 · 2024-12-18T06:51:46+0000

we have designed one PCB which consists 6 RF chains. In one single chain it consists of limiter+lna+spdt.

we are getting good s parameters (gain, return loss) only issue is we have observed reflections at the ports

we have crosscheck whether it is due to poor impedance mismatch, every thing is good with respective to impedance matching and grounding.
can any one respond regarding this issue.

vfone · 2024-12-18T07:24:33+0000

How can you have "good return loss" and have reflections (probably high VSWR) in the same time?

hanif · 2024-12-18T09:04:11+0000

nikhil_56 said:
we have designed one PCB which consists 6 RF chains. In one single chain it consists of limiter+lna+spdt.

we are getting good s parameters (gain, return loss) only issue is we have observed reflections at the ports

we have crosscheck whether it is due to poor impedance mismatch, every thing is good with respective to impedance matching and grounding.
can any one respond regarding this issue.

Check this link

How to Avoid Signal Reflection in PCB - RAYPCB

Introduction Signal reflection occurs when an electrical signal encounters an impedance discontinuity along a transmission line, causing a portion of the signal to be reflected back towards the source. This can lead to interference issues like ringing and noise in high speed PCBs. Properly...

www.raypcb.com

Reflection's in PCB

nikhil_56

Newbie level 6

vfone

Advanced Member level 6

hanif

Full Member level 4

How to Avoid Signal Reflection in PCB - RAYPCB

Similar threads

Reflection's in PCB

nikhil_56

Newbie level 6

vfone

Advanced Member level 6

hanif

Full Member level 4

How to Avoid Signal Reflection in PCB - RAYPCB

Similar threads

Privacy & Transparency

Privacy & Transparency