Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
i'm not sure but you could make a crude one yourself
you could make blades to rotate due to the flow and put some damping
then, no of revolutions in unit time will be proportional to the speed
Here is a link to speed/velocity sensor based on a rotor and magnets:
**broken link removed**
Maybe you can try to adopt this idea in your project.
Good luck and regards,
IanP
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.