rasberry py interfacing with am26ls31

Status
Not open for further replies.

raman00084

Full Member level 6
Joined
Nov 29, 2010
Messages
375
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Visit site
Activity points
4,076
i am driving a servo motor in step and direction mode. my servo accepts only differential step pulses ( step+ step-). from rasberry pye i am generating square pulse train that is fed to am26ls31 input the output of am26ls31 is differential (rs 485) that is fed to the servo drive. my doubt is rasberry pye operates in 3.3v but am26ls31 supply voltage is 5v will there be any problem to the pye?

what i fell is i am not receiving any thing but i am just transmitting 3.3v pulse train to am26ls31 ic will it burn my pye io

kindly help


regards
kalyan
 

Hi,

are you sure step+ and step- are for differential signalling? Maybe step+ is for forward and step- is for backward. Check this.

If differential signalling.
just connect the Am26. Vcc and GND as usual. enable driver,
for the data i recommend to use an output with waveform generation ability. Then you may configure the controller to output a desired frequency without the need for processing power.

Klaus
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…