emax0198
Member level 2
- Joined
- Nov 21, 2004
- Messages
- 45
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,286
- Activity points
- 500
R/C receiver antenna
I have made a test circuit for a radio control system at 72MHz based on the design from:
**broken link removed**
I am having a problem of antenna placement. The antenna is about 36 inch wire hanging from the PCB. When I place the antenna on the ame surface where the RX is placed I get servo jitter at the output but when I hang the antenna down or tie it at a little height then the jitter reduces.
What could be the reason for this and what is the solution?
I have made a test circuit for a radio control system at 72MHz based on the design from:
**broken link removed**
I am having a problem of antenna placement. The antenna is about 36 inch wire hanging from the PCB. When I place the antenna on the ame surface where the RX is placed I get servo jitter at the output but when I hang the antenna down or tie it at a little height then the jitter reduces.
What could be the reason for this and what is the solution?