question: mapping nets between Cadence schematic and Calibre RC view

Status
Not open for further replies.

cmos_ajay

Full Member level 2
Joined
Jan 30, 2007
Messages
126
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Visit site
Activity points
2,247
I have a Cadence schematic view and its Layout. I also have a Calibre RC extracted view. There is a pmos device M20 in my schematic and I would like to see the voltage on the gate of M20.
How do I map the gate of M20 from the schematic view to that in the Calibre RC extracted view ???
Can someone help ?
 

I am not sure how to do this. I tried to see the voltage of gate of M20 pmos device which is inside a hierarchy. Can you explain the procedure ?
It seems the Calibre extracted view assigns a different net name .
 

It seems the Calibre extracted view assigns a different net name .

Sure, like any extracted view. If I remember well, the cross-mapping feature is somewhere in the LVS menu. See the Cādence docu.
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…