Question About HFSS Port Renormalizing

Status
Not open for further replies.

Mads Hedegaard Larsen

Newbie level 3
Joined
Oct 16, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,302
I am currently running a simulation on a transmission line where i use two lumped ports:

Port 1 have an Impedance of 50 Ohm
Port 2 an Impedance of 10 kOhm - 132j Ohm

I am looking at the coupling between the two ports, in other words: S12
So should I run with both ports renormalized to get the correct S12 or not?

Thanks a lot,
Mads


Ps. I noticed that by default, lumped ports are renormalized to a 50 Ohm full port impedance, which means that the renormalization only really matter for port 2.
 
Last edited:

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…