Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

PSoC1 programming

Status
Not open for further replies.
The IDE is PSOC Designer 5.4



Debug and programming was done with ICE-CUBE -

https://www.mouser.com/datasheet/2/100/38-12028_CY8C24123A_CY8C24223A_CY8C24423A_PSOC_PRO-769501.pdf page 58

Programming only (not sure if this applies)


Also miniprog1 for programming only.


Regards, Dana.
--- Updated ---

Question, are you working with this part because its designed into an existing
product ? Reason I ask is PSOC 4 and 5LP are new families with much better
interface and tools.

Regards, Dana.
 
Last edited:

Also miniprog1 for programming only.


Regards, Dana.
--- Updated ---

Question, are you working with this part because its designed into an existing
product ? Reason I ask is PSOC 4 and 5LP are new families with much better
interface and tools.

Regards, Dana.
Yes, I'm trying to work with this part because it is designed into an already existing product https://github.com/14Point7/SLC-Free .
I have seen the miniprog1, but for its price I could already buy two already made controllers, so its just not worth to buy miniprog1 for one time use. Tried searching for some DIY programmers and came accros some old threads using some kind of homemade programmer and CYP software, but threads are very old and all the links are dead.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top