PS_MIO_VREF_501 signal in ZYNQ why connected to VREF0V9

engr_joni_ee · Dec 27, 2020

Hi,

I have attached PS MIO Bank schematic of ZYBO development board. The MIO Bank 501 is powered up by 1.8 V and MIO Bank 500 is powered up by 3.3 V.

I am wondering why the signal PS_MIO_VREF_501 in MIO Bank 501 is connected to VREF0V9 ? and why not connected to GND ? What about if we leave it un-connected in the new board ?

FvM · Dec 27, 2020

You want to read the ZYBO-Z7 reference manual...

The Zynq incorporates two independent Gigabit Ethernet Controllers. They implement a 10/100/1000 half/full duplex Ethernet MAC. Of these two, GEM 0 can be mapped to the MIO pins where the PHY interfaces. Since the MIO bank is powered from 1.8V, the RGMII interface uses 1.8V HSTL Class 1 drivers. For this I/O standard an external reference of 0.9V is provided in bank 501 (PS_MIO_VREF). Mapping out the correct pins and configuring the interface is handled by the Zybo Z7 Vivado board files.

PS_MIO_VREF_501 signal in ZYNQ why connected to VREF0V9

engr_joni_ee

Advanced Member level 3

Attachments

FvM

Super Moderator

engr_joni_ee

Similar threads

PS_MIO_VREF_501 signal in ZYNQ why connected to VREF0V9

engr_joni_ee

Advanced Member level 3

Attachments

FvM

Super Moderator

Similar threads

Privacy & Transparency

Privacy & Transparency