Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Proteus bus fault error with stm32

Status
Not open for further replies.
U

ultrasonic.1991

Member level 3
Member level 3
Joined
Nov 6, 2015
Messages
60
Helped
0
Reputation
0
Reaction score
0
Trophy points
6
Activity points
554
Hi, i want to simulate a simple led blink register code with proteus but it gives me 9700 errors as shown below. The code works in real-time and in the Keil simulator. In addition, i tested proteus with another code that was produced by stm32cube and i just added my code and loaded the hex file on the stm32 in proteus, and it worked fine but i don't know what is the problem with this code.
 

Attachments

  • proteus 2.png
    proteus 2.png
    41.7 KB · Views: 472
  • proteus.png
    proteus.png
    56.3 KB · Views: 189
  • proteus3.png
    proteus3.png
    22.8 KB · Views: 203

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top