Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problems with P_Probe in a design of a Mixer

F

fide961

Newbie
Newbie level 1
Joined
May 2, 2024
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
20
Hello everyone,
I am trying to measure the power of each part in a sub-harmonic mixer to check that the filters don't have anything wrong, but I have problems. Somebody knows what happens. Here is a picture of the design and the graphics. I used the same P_Probe in a solitary filter with this harmonic balancer analysis and obtained the normal behavior, but here I have something different.
Thanks in advance for the help.
 

Attachments

  • 2eraPruebadepotenciasenmodelojose.PNG
    2eraPruebadepotenciasenmodelojose.PNG
    108.2 KB · Views: 58
  • 1eraPruebadepotenciasenmodelojose.PNG
    1eraPruebadepotenciasenmodelojose.PNG
    85.8 KB · Views: 57
  • 3eraPruebadepotenciasenmodelojose.PNG
    3eraPruebadepotenciasenmodelojose.PNG
    74.8 KB · Views: 57
  • 4taPruebadepotenciasenmodelojose.PNG
    4taPruebadepotenciasenmodelojose.PNG
    41 KB · Views: 65
Sort by date Sort by votes
You say "I'm just doing Mixer Simulation" but You use Small Signal S-Parameters...
What do you expect from this nonsense simulation set-up ?
Do you have a solid knowledge about Mixers ?
 
Upvote 0 Downvote

LaTeX Commands Quick-Menu:

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top