Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem with using periodic simulation in CST Microwave Studio

Status
Not open for further replies.

R90

Newbie level 3
Newbie level 3
Joined
May 4, 2011
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,301
Good Morning ..
I Was Facing A Problem That I Wanted To Simulate A Part Of The Structure (Leaky Wave Antenna) Using The Periodic Simulation (Periodic Boundary Conditions)
So I Would Like To Know The Specifications Which Should Be Applied For This Simulation To Run Successfully .. Note That I Have Tried It Once But It Gave Me Out Wrong Results
And Some Doctors Told Me That The Problem Is With The Boundaries That It Must Be The Same Size As The Structure Itself .. I Tried Doing This But It Gave Me Out A Warning
Telling Me That The Ports Shouldn't Touch The Boundary Box.
Best Regards ..
Thank You !
 

If you are using CST there is a boundary condition for periodicity. as long as you have your frequency range setup it should automatically size the boundary box.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top