Problem with thickness/sub height ratio error in Designer

Status
Not open for further replies.
H

hitmo

Member level 1
Joined
Jan 4, 2005
Messages
37
Helped
2
Reputation
4
Reaction score
1
Trophy points
1,288
Activity points
287
Designer

hi
i am designing a filter which is given in G.Matthaei text book. the filter is bsf desinged using stripline, height of sub 312mil and conductor thickness is 125 mils. whn i try to simulate it using designer it gives me a error sayin that thickness/sub height ratio should be less ≤ 0.25. is there a way around that.
 

Designer

Conductor Thickness is 125 mils? I think it is wrong.
Normally, Conductor thickness is 0.675mil or 1.35mil.
 

Re: Designer

hi
the conductor thickness is 125 mil which is need to get high Q whn the sub thickness is high.
 

Re: Designer

Is this an etched board? Or is it something milled out of solid material then glued together? I assume the strip has a rectangular cross-section?

125mils is more like something you'd use for a busbar in a power supply than as a filter.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…