Mar 22, 2013 #1 S savan Junior Member level 3 Joined Sep 3, 2010 Messages 25 Helped 1 Reputation 2 Reaction score 0 Trophy points 1,281 Activity points 1,445 I am designing DVCC block on CIS capture (proposed by Elwan and Solimon) I am facing following error after I save my design and ORCAD closes afterwards. Any hints suggestions? Thanks in advance Similar post was also started but has not been solved yet! please help!
I am designing DVCC block on CIS capture (proposed by Elwan and Solimon) I am facing following error after I save my design and ORCAD closes afterwards. Any hints suggestions? Thanks in advance Similar post was also started but has not been solved yet! please help!
Apr 5, 2013 #2 S sarvanbhakya Newbie level 6 Joined Mar 1, 2013 Messages 12 Helped 0 Reputation 0 Reaction score 0 Trophy points 1,281 Activity points 1,341 Two reason one is ur orcad is not installed properly or UR processor pblm
May 7, 2013 #3 A abhajn Junior Member level 3 Joined Mar 25, 2008 Messages 26 Helped 10 Reputation 20 Reaction score 7 Trophy points 1,283 Activity points 1,420 To check your installation, you could open one of the example designs shipped with Capture. (They are located at <installation folder>\tools\pspice\capture_samples\anasim) If they work, then the crash could be design-specific.
To check your installation, you could open one of the example designs shipped with Capture. (They are located at <installation folder>\tools\pspice\capture_samples\anasim) If they work, then the crash could be design-specific.