problem with proteus

Status
Not open for further replies.
S

sead

Newbie level 5
Joined
Feb 21, 2013
Messages
8
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Visit site
Activity points
1,325
how to set a center tap transfomer;primary is 230v to secondary 9v using proteus?
 

didn't get it.where do you create/edit the value at?
 

From the generator mode select two SINE wave signals as a input.
Put RMS voltage 115 and -115 with 50Hz frequency.
This create your 230V AC,50Hz sign wave input signal.

Then edit properties of the transformer component.
Set coupling factor as 0.0554.
to get exact 9V for center tap transformer.

Check with oscilloscope and AC volt meter.
 
Reactions: sead

    S

    sead

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…