JulianLee321
Newbie level 1
I am new to Pads Logic, when I tried to add the ground symbol, I always get the warning message stating that “Part selected is an off-page and not a component. I notice that when I right click on the existing ground symbol of the sample schematic circuit, there is no option to copy the ground symbol , hence I can’t copy and paste the ground symbol to proceed too. This is unlike other component symbols (eg. Resistors, Op-amp etc ) which I can readily “edit part “ or copy and paste the part .
Can anyone advise how this problem can be overcome ?
Thank you very much in advance for your help.
Regards,
Julian
Can anyone advise how this problem can be overcome ?
Thank you very much in advance for your help.
Regards,
Julian