Problem with Interactive Length Tuning for Parallel Signal using Altium.

Status
Not open for further replies.
K

kahjoo

Junior Member level 2
Joined
Jul 23, 2012
Messages
21
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,456
Hi,


I'm having trouble of making the Interactive Length Tuning for the Parallel signal trace.
I've make the setting as on below but the result of the trace are not as "Mitered with Arcs" as setting picture below.

Any setting that need to set in order to the "Mitered with Arcs" trace pattern?

Currently using Alitum Designer 10.



 

I don't use Altium, but try mitred with 45 deg if it has it, may not be able to form the arcs, worth a try....
 

Review the online documentation and see that mitering with arcs is well supported for 45 degree routes.

I think it's just a problem of inappropriate parameters. By the way, what's your trace width if gap is set to 0.2 mm?

The documentation example shows how miter radius can be interactively adjusted, as usual all setting are accessable through CTRL-F1.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…