Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem in using PLL - need 108Mhz signal to clock EPM7064S

Status
Not open for further replies.
R

Rameez Ahmad

Newbie level 1
Newbie level 1
Joined
Dec 18, 2009
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
SSE,Lums
Activity points
1,287
Hi,I am using this chip Cdcs502 from Ti.I am running a 27Mhz crystal and connecting Capacitor load of 35pF ,with FS=0,the output is a clock pulse with 0.8 low and 2.1 high,i think this is fine.But the problem is when i do FS=1,the frequency gets 108Mhz but the amplitude becomes very low , the peak to peak amplitube is 800mV having a DC offset of 1.6 V...Kindly help me with this..]

I need this 108Mhz signal to clock my EPM7064S.

Kindly help!!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top