Reply to thread

hello,

I'm trying to run sx1281 lora ic from semtech with stm32 by uart protocol

1- at the first I reset hardware by reset pin and then

2- send getstatus() command to get mode of ic , for this command I examine BUSY pin to be Low after that I transmit getstatus() command, ic response me STDBY_RC mode and it's ok

3- depends on datasheet then I should to setpackettype(), when I send setpackettype() command or any SET command, voltage of BUSY pin goes to high and remain high!! and I can't send another commands!! I expect after set command busy pin goes to low voltage

please help